Lexus ES manuals

Lexus ES: Blind Spot Monitor Sensor

READ NEXT:

 Adjustment

ADJUSTMENT PROCEDURE 1. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION HINT: The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and per

 Components

COMPONENTS ILLUSTRATION *1 BLIND SPOT MONITOR COVER LH *2 BLIND SPOT MONITOR COVER RH *3 BLIND SPOT MONITOR SENSOR LH *4 BLIND SPOT MONITOR SENSOR RH N*m (kgf*cm, ft.*lbf) :

 Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: Avoid any impact to the blind spot monitor sensor. Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one. HINT:

SEE MORE:

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof housing removal/installation are shown below. Necessary Procedure After Parts Removed/Insta

 Terminals Of Ecu

TERMINALS OF ECU PARKING ASSIST ECU (a) Disconnect the N44 parking assist ECU connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition N44-1 (+B) - N44-4 (GND1

© 2016-2023 Copyright www.lexguide.net