Lexus ES: A25a-fks Drive Belt
READ NEXT:
Components
COMPONENTS
ILLUSTRATION
*1
NO. 2 ENGINE UNDER COVER ASSEMBLY
*2
V-RIBBED BELT
*3
FRONT WHEEL OPENING EXTENSION PAD LH
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Click here
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Click here
3. REMOVE NO. 1 ENGINE UNDER COVER
Click here
Installation
INSTALLATION
PROCEDURE
1. INSTALL V-RIBBED BELT
HINT:
When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt
for wear and cracks. If wear or a crack that reaches the core (
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side turn signal light assembly removal/installation are shown below. Necessary Procedure After Parts R
Operation Check
OPERATION CHECK REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) SELF CHECK NOTICE:
Before entering self-diagnostic mode, make sure there are no obstructions which may interfere with operation of the remote touch screen, and that the remote touch screen is not dirty.
Do not touch the remote
© 2016-2026 Copyright www.lexguide.net
