Lexus ES manuals

Lexus ES: Wheels

If a wheel is bent, cracked or heavily corroded, it should be replaced.

Otherwise, the tire may separate from the wheel or cause a loss of handling control.

Wheel selectio

When replacing wheels, care should be taken to ensure that they are equivalent to those removed in load capacity, diameter, rim width and inset*.

Replacement wheels are available at your Lexus dealer.

*: Conventionally referred to as offset.

Lexus does not recommend using the following:

■When replacing wheels The wheels of your vehicle are equipped with tire pressure warning valves and transmitters that allow the tire pressure warning system to provide advance warning in the event of a loss in tire inflation pressure.

Whenever wheels are replaced, tire pressure warning valves and transmitters must be installed.

WARNING

■When replacing wheels

■Use of defective wheels prohibited Do not use cracked or deformed wheels.

Doing so could cause the tire to leak air during driving, possibly causing an accident.

NOTICE

■Replacing tire pressure warning valves and transmitters

Aluminum wheel precautions

READ NEXT:

 Air conditioning filter

The air conditioning filter must be changed regularly to maintain air conditioning efficiency. Removing the air conditioning filter 1. Turn the power switch off. 2. Open the glove box. 3. R

 Cleaning the hybrid battery (traction battery) air intake vent and filter

To prevent the fuel economy from being affected, visually inspect the hybrid battery (traction battery) air intake vent periodically for dust and clogs. If it is dusty or clogged or if "Maintenan

 Electronic key battery

Replace the battery with a new one if it is depleted. ■If the electronic key battery is depleted The following symptoms may occur: The smart access system with push-button start and wireles

SEE MORE:

 DC/DC Converter Voltage Sensor "A"(VL) Circuit Voltage Above Threshold (P0E5717)

DTC SUMMARY MALFUNCTION DESCRIPTION If an overvoltage malfunction occurs in the motor inverter or generator inverter, the motor generator control ECU (MG ECU) detects the malfunction and stores this DTC. The cause of this malfunction may be one of the following: Area Main Malfunction Descriptio

 Open Circuit in Main Relay 1 (C1311,C1312)

DESCRIPTION The main relay supplies power to the switching solenoid and the linear solenoid. The main relay remains on for approximately 2 minutes after the power switch is turned off and the input of brake pedal operation signals stops, and supplies power to the system to keep it ready to operate.

© 2016-2026 Copyright www.lexguide.net