Lexus ES: Ultrasonic Sensor (for Front)
Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Ultrasonic Sensor (for Front)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT CENTER ULTRASONIC SENSOR *2 FRONT CORNER ULTRASONIC SENSOR *3 FRONT CORNER ULTRASONIC SENSOR RETAINER - - ● Non-reusable part - - IL
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT CENTER ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Spec
Installation
INSTALLATION PROCEDURE 1. INSTALL ULTRASONIC SENSOR CUSHION SET HINT: Only perform this procedure when removing and installing the ultrasonic sensor cushion set. (a) Install the ultrasonic sensor cush
SEE MORE:
Throttle/Pedal Position Sensor/Switch "B" Circuit Short to Battery or Open (P022015)
DESCRIPTION Refer to DTC P012011. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P022015 Throttle/Pedal Position Sensor/Switch "B" Circuit Short to Battery or Open The output voltage of VTA2 is higher than 4.75 V, and VTA1 is less than
Open in One Side of Bus 5 Branch Line
DESCRIPTION When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Check" screen changes in
© 2016-2026 Copyright www.lexguide.net
