Lexus ES: Steering Angle Sensor (C1A47)
DESCRIPTION
The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication.
Blind Spot Monitor Master| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A47 | Steering Angle Sensor | A fail flag is transmitted from the steering angle sensor |
|
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A47 | Steering Angle Sensor | A fail flag is transmitted from the steering angle sensor |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. | CHECK DTC |
(a) Turn the power switch off.
(b) Turn the power switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble CodesOK:
No DTCs are output.
| OK | .gif) | USE SIMULATION METHOD TO CHECK |
|
.gif)
| 2. | REPLACE STEERING SENSOR |
(a) Replace the steering sensor with a new or known good one.
Click here .gif)
|
| 3. | RECHECK DTC |
(a) Turn the power switch off.
(b) Turn the power switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTC C1A47 is output ("Blind Spot Monitor Master") | B |
| DTC C1A47 is output ("Blind Spot Monitor Slave") | C |
| A | | END |
| B | | REPLACE BLIND SPOT MONITOR SENSOR RH |
| C | | REPLACE BLIND SPOT MONITOR SENSOR LH |
READ NEXT:
Short to +B in Outer Mirror Indicator(Master) (C1AB0)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to +B in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Trouble A
Short to +B in Outer Mirror Indicator(Slave) (C1AB1)
DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects a short to +B in the outer rear view mirror indicator LH. DTC No. Detection Item DTC Detection Condition Trouble A
Short to GND in Outer Mirror Indicator(Master) (C1AB2)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to ground in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Troub
SEE MORE:
Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor A (P001600)
DESCRIPTION Refer to DTC P001001. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P001600 Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor A Deviation in the crankshaft position sensor signal and camshaft position senso
VSC does not Operate or VSC does not Operate Correctly
DESCRIPTION When TRAC or VSC is operating, the skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred. When a communication malfunction with the ECM is detected, TRAC and VSC are disabled. Also, TRAC and VSC are disabled when a DTC is s
