Lexus ES manuals

Lexus ES: Software Incompatibility with Brake System Control Module Not Programmed (U031851)

Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Cruise Control / Dynamic Radar Cruise Control System (for Hv Model) / Software Incompatibility with Brake System Control Module Not Programmed (U031851)

DESCRIPTION

If the forward recognition camera cannot verify the vehicle information sent from the skid control ECU (brake booster with master cylinder assembly), the forward recognition camera stores DTC U031851.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

DTC Output from

U031851

Software Incompatibility with Brake System Control Module Not Programmed

The vehicle information sent from the skid control ECU (brake booster with master cylinder assembly) cannot be verified by the forward recognition camera.

Forward recognition camera

Does not come on

Radar Cruise2

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.
  • If the forward recognition camera has been replaced with a new one, it is necessary to perform forward recognition camera adjustment.

    HINT:

    Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.

    One Time Recognition: Click here

    Sequential Recognition: Click here

PROCEDURE

1.

REPLACE FORWARD RECOGNITION CAMERA

(a) Replace the forward recognition camera with a new one.

Click here

NEXT

2.

CLEAR DTC

(a) Clear the DTCs.

Powertrain > Radar Cruise2 > Clear DTCs
NEXT

END

READ NEXT:

 Software Incompatibility with Brake System Control Module Invalid/Incompatible Software Component (U031857)

DESCRIPTION If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the skid control ECU (brake booster with master cylinder assembly), the

 Software Incompatibility with Body Control Module Not Programmed (U032251)

DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the main body ECU (multiplex network body ECU), the forward recognition camera stores DTC U032251. DTC

 Software Incompatibility with Body Control Module Invalid/Incompatible Software Component (U032257)

DESCRIPTION If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the main body ECU (multiplex network body ECU), the forward recognition

SEE MORE:

 Generator Temperature Sensor Voltage Out of Range (P0A361C,P0A361F)

DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs are stored when the generator temperature sensor output is abnormal. The cause of this malfunction may be one of the following: Generator temperature sensor malfunction Internal generator temperature sensor malfunction Open or short in generator te

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR LIGHT ASSEMBLY (a) Engage the clip. *a Nut *b Cap Nut (b) Install the rear light assembly with

© 2016-2024 Copyright www.lexguide.net