Lexus ES: Right Rear Wheel Speed Sensor Signal Stuck High (C051224)
DESCRIPTION
Refer to DTC C051212
Click here
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
| C051224 | Right Rear Wheel Speed Sensor Signal Stuck High | The speed sensor signal is not within the specified range for 5 seconds or more. | Rear speed sensor RH (rear axle hub and bearing assembly RH) |
CAUTION / NOTICE / HINT
NOTICE:
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Click here
PROCEDURE
| 1. | REPLACE REAR AXLE HUB AND BEARING ASSEMBLY RH |
(a) Replace the rear axle hub and bearing assembly RH.
Click here
| NEXT | | END |
READ NEXT:
DESCRIPTION Refer to DTC C051212 Click here DTC No. Detection Item DTC Detection Condition Trouble Area C051224 Right Rear Wheel Speed Sensor Signal Stuck High The speed sensor sign
DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC
DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below. Necessary Procedures After Parts
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
Some Data List values may vary significantly if there are slight differences in the environment in which the vehicle is operating when measurements are obtained. Variations may also occur due to aging of the vehicle. Due to these considerations, it is not
© 2016-2026 Copyright www.lexguide.net
