Lexus ES: Right Rear Wheel Speed Sensor Signal Stuck High (C051224)
Lexus ES (XZ10) Service Manual / Brake / Brake Control / Dynamic Control Systems / Electronically Controlled Brake System (for Gasoline Model) / Right Rear Wheel Speed Sensor Signal Stuck High (C051224)
DESCRIPTION
Refer to DTC C051212
Click here .gif)
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C051224 | Right Rear Wheel Speed Sensor Signal Stuck High | The speed sensor signal is not within the specified range for 5 seconds or more. |
|
*1: for 2WD
*2: for AWD
CAUTION / NOTICE / HINT
NOTICE:
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Click here
PROCEDURE
| 1. | CHECK VEHICLE |
(a) Check the vehicle specification.
| Result | Proceed to |
|---|---|
| for 2WD | A |
| for AWD | B |
| A |  | REPLACE REAR AXLE HUB AND BEARING ASSEMBLY RH |
| B | | REPLACE REAR SPEED SENSOR RH |
READ NEXT:
Right Rear Wheel Speed Sensor Internal Electronic Failure (C051249)
DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC
Right Rear Wheel Speed Sensor Internal Electronic Failure (C051249)
DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC
Multi-axis Acceleration Sensor Module "A" Component Internal Failure (C052096)
DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) receives signals from the yaw rate
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CLEARANCE WARNING ECU ASSEMBLY (a) Disconnect the N41 clearance warning ECU assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Description C
Steering Angle Sensor Failure (C1626)
DESCRIPTION
This DTC is stored if the parking assist ECU receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.
This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the steering sensor that indic
© 2016-2026 Copyright www.lexguide.net
