Lexus ES: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during luggage closer motor assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Luggage closer motor assembly | Initialize power trunk lid system | Power Trunk Lid System | |
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Luggage closer motor assembly | Initialize power trunk lid system | Power Trunk Lid System | |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT
Click here .gif)
2. REMOVE SPARE WHEEL COVER TRAY
Click here
3. REMOVE REAR FLOOR FINISH PLATE
Click here
4. REMOVE LUGGAGE LOCK CONTROL CABLE PLATE
Click here
5. REMOVE SWITCH BEZEL
Click here
6. REMOVE LUGGAGE COMPARTMENT DOOR COVER
Click here
7. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH
HINT:
Use the same procedure as for the LH side.
Click here
8. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH
Click here
9. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER RH
Click here
10. REMOVE LUGGAGE CLOSER MOTOR ASSEMBLY
| (a) Remove the nut. |
|
(b) Remove the 3 bolts.
| (c) Disengage the 2 guides. |
|
| (d) Disengage the 2 clamps. |
|
(e) Disconnect the connector to remove the luggage closer motor assembly.
11. REMOVE DECK SIDE TRIM COVER RH
| (a) Disengage the clip and remove the deck side trim cover RH. |
|
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL DECK SIDE TRIM COVER RH (a) Engage the clip to install the deck side trim cover RH. 2. INSTALL LUGGAGE CLOSER MOTOR ASSEMBLY (a) Connect the connector. (b) Engage the
SEE MORE:
Drive Motor "A" Inverter Stuck On (P0A789E,P1C5D19)
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC indicates that a large current flowed through the motor inverter. The cause of this malfunction may be one of the following: Area Main Malfunction Description Hybrid vehicle transaxle assembly
Open or short circuit in the motor coils
Motor
Lost Communication With ECM/PCM "A" (U0100,...,U1117)
DESCRIPTION These DTCs are stored if a CAN communication malfunction occurs between the main body ECU (multiplex network body ECU) and other ECUs. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U0100 Lost Communication With ECM/PCM "A" The main body EC
