Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL DECK SIDE TRIM COVER RH
(a) Engage the clip to install the deck side trim cover RH.
2. INSTALL LUGGAGE CLOSER MOTOR ASSEMBLY
(a) Connect the connector.
(b) Engage the 2 clamps.
(c) Engage the 2 guides.
| (d) Install the luggage closer motor assembly with the 3 bolts. HINT: Tighten the bolts in the order shown in the illustration. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} |
|
(e) Align the protrusion of the power luggage door rod sub-assembly with the edge of luggage compartment door hinge assembly RH and connect the power luggage door rod sub-assembly as shown in the illustration.
(f) Install the nut.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
3. INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER RH
Click here .gif)
4. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH
Click here
5. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER RH
HINT:
Use the same procedure as for the LH side.
Click here
6. INSTALL LUGGAGE COMPARTMENT DOOR COVER
Click here
7. INSTALL SWITCH BEZEL
Click here
8. INSTALL LUGGAGE LOCK CONTROL CABLE PLATE
Click here
9. INSTALL REAR FLOOR FINISH PLATE
Click here
10. INSTALL SPARE WHEEL COVER TRAY
Click here
11. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
Click here
12. INITIALIZE POWER TRUNK LID SYSTEM
for Gasoline Model:
Click here
for HV Model:
Click here
13. INSPECT POWER TRUNK LID OPERATION
for Gasoline Model:
Click here
for HV Model:
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *1 COURTESY LIGHT ASSEMBLY *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY *3 MULTIPLEX NETWORK MASTER SWITCH ASS
SEE MORE:
Stereo Jack Adapter Light does not Illuminate
DESCRIPTION Power is supplied to the No. 1 stereo jack adapter assembly illumination from the radio receiver assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or cali
Components
COMPONENTS ILLUSTRATION *1 BATTERY SERVICE HOLE COVER *2 SERVICE PLUG GRIP ILLUSTRATION *1 CONNECTOR COVER ASSEMBLY *2 ENGINE ROOM MAIN WIRE Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf)
