Lexus ES: Rear Disc Brake Pad
READ NEXT:
Components
COMPONENTS
ILLUSTRATION
*1
NO. 2 PARKING BRAKE WIRE ASSEMBLY
*2
REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
*3
REAR DISC BRAKE PAD
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the brake pads, the braking performance
may be reduced. Always perform a road test in a safe place while paying
SEE MORE:
Inspection
INSPECTION CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
PROCEDURE 1. INSPECT REAR DRIVE SHAFT ASSEMBLY (a) Check that there is no excessive play in the radial direction of the outboard joint.
Removal
REMOVAL PROCEDURE 1. REMOVE REAR FLOOR SIDE MEMBER COVER (a) Remove the bolt and 7 clips. (b) Disengage the 3 clamps (A) and 2 clamps (B) to remove the rear floor side member cover from the vehicle body. 2. REMOVE CANISTER (CHARCOAL CANISTER ASSEMBLY) (a) Disconnect the fuel tank vent
© 2016-2025 Copyright www.lexguide.net
