Lexus ES: Rear Differential Carrier Oil Seal
Lexus ES (XZ10) Service Manual / Drivetrain / Axle And Differential / Rear Differential Carrier Oil Seal
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR DIFFERENTIAL CARRIER ASSEMBLY *2 REAR NO. 1 DIFFERENTIAL SUPPORT *3 REAR NO. 2 DIFFERENTIAL SUPPORT - - Tightening torque for "Major areas in
Replacement
REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR (a) Type A (1) Install the No. 2 exhaust manifold heat insulator to the exhaust manifold (TWC: Front Catalyst) with the 6 bolts. Torque: 11 N·m {112 kgf·cm, 8 ft·lbf} (b) Type B (1) Install the No. 2 exhaust manifold heat in
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT DRIVE SHAFT OIL SEAL RH (a) Hold the differential case assembly in a vise between aluminum plates. NOTICE: Do not overtighten the vise. (b) Using SST, remove the front drive shaft oil seal RH from the differential case assembly. SST: 09308-00010 N
© 2016-2026 Copyright www.lexguide.net
