Lexus ES: Rear Differential Carrier Assembly
Lexus ES (XZ10) Service Manual / Drivetrain / Axle And Differential / Rear Differential Carrier Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR DIFFERENTIAL CARRIER ASSEMBLY *2 WIRE HARNESS CLAMP BRACKET *3 REAR UPPER DIFFERENTIAL MOUNT STOPPER *4 REAR LOWER DIFFERENTIAL MOUNT STOPPER *5
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: Before installation of each part, thoroughly clean and dry it. Then apply gear oil to it. Do not use alkaline chemicals to clean aluminum parts, rubber part
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DIFFERENTIAL SUPPORT (a) Install the rear differential support to the rear differential carrier assembly with 4 new bolts. Torque: 72 N·m {734 kgf·cm, 53 ft·
SEE MORE:
Power Source Circuit
DESCRIPTION This circuit provides power to operate the blind spot monitor sensor. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCEDURE 1. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR
DC/DC Converter Voltage Sensor "A"(VL) Circuit Intermittent (P314F1F)
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC is stored if the value of "VL Voltage" fluctuates excessively. The cause of this malfunction may be one of the following: Area Main Malfunction Description Hybrid vehicle transaxle assembly
Open or short circuit in the motor or generator coi
© 2016-2026 Copyright www.lexguide.net
