Lexus ES: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
-
When a symptom indicates that a service is malfunctioning, use the Techstream to check whether the service subscription is active.
Click here
.gif)
| Symptom | Suspected Area | Link |
|---|---|---|
| "Communication Module failure detected, please contact your dealer" message is played | Diagnostic Trouble Code Chart (Red Indicator has failed and cannot indicate a failure) | |
| "Communication Module Activation Failed" message is played | Verify any network problems by calling the Lexus Customer Assistance Center and select prompt for "Lexus Enform with Safety Connect" | - |
| Wait for a while, then move to different location and retry (try to find location with better signal reception) | - | |
| Diagnostic Trouble Code Chart | | |
| "Unable to Connect the Emergency Call Center" or "Unable to Connect to the Call Center" message is played | Verify any network problems by calling the Lexus Customer Assistance Center and select prompt for "Lexus Enform with Safety Connect" | - |
| Wait for a while, then move to different location and retry (try to find location with better signal reception) | - | |
| Perform Vehicle Inquiry on Techstream and verify subscription status | - | |
| Refer to UNABLE TO CONNECT TO CALL CENTER | | |
| "Safety Connect is not active" message is played | Perform Vehicle Inquiry on Techstream and verify subscription status | - |
| Explain to the customer that the system is in shipping mode, and confirm whether or not they would like to change to active mode | - |
| Symptom | Suspected Area | Link |
|---|---|---|
| Green indicator abnormal (Remains OFF) | Refer to GREEN INDICATOR REMAINS OFF | |
| Red indicator abnormal (Remains ON) | Refer to RED INDICATOR REMAINS ON | |
| Illumination on the manual (SOS) switch panel does not turn on | Proceed to "Emergency Call Switch Illumination Circuit" | |
| Symptom | Suspected Area | Link |
|---|---|---|
| The operator's voice is wavering/choppy during the emergency call | Set the volume at the default or lower if the customize volume is set to a value larger than the default | |
READ NEXT:
Red Indicator Remains On
DESCRIPTION This means that the DCM (telematics transceiver) has detected a malfunction in the safety connect system and stored a DTC or specific vehicle control history (RoB) Code. PROCEDURE 1.
System Diagram
SYSTEM DIAGRAM
Terminals Of Ecu
TERMINALS OF ECU Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition G128-1 (+B) - G128-20 (E) BR - W-B Power source (+B) Power switch off 11
SEE MORE:
Parts Location
PARTS LOCATION ILLUSTRATION *1 LUGGAGE DOOR OPENING CANCEL SWITCH ASSEMBLY *2 TRUNK AND FUEL SWITCH ASSEMBLY *3 LUGGAGE COMPARTMENT DOOR OPENING SWITCH *4 DLC3 *5 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *6 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ECU-DCC NO. 2 FUSE
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of
