Lexus ES: Noise Filter
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for HV Model *B for Gasoline Model *1 RADIO SETTING CONDENSER *2 REAR DOOR SCUFF PLATE LH *3 REAR SEAT SIDE GARNISH LH *4 ROOF SIDE INNER GARNI
Installation
INSTALLATION PROCEDURE 1. INSTALL RADIO SETTING CONDENSER (a) Engage the claw to install a new terminal cover to the wire harness. NOTICE:
Make sure to hold the crimped side of the terminal wh
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RADIO SETTING CONDENSER (a) With the radio setting condenser installed, check that there is no looseness or other abnormalities. (b) Measure the resistanc
SEE MORE:
Replacement
REPLACEMENT PROCEDURE 1. REPLACE STRAIGHT PIN NOTICE: If a straight pin is deformed, replace it. (a) Using a plastic hammer, tap in new straight pins to the cylinder block sub-assembly. *a Front Side *b Rear Side *c Top Side *d Bottom Side *e RH Side *f 23 mm (0.906 in.
Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Ground (P032511,P033011)
DESCRIPTION A flat-type knock control sensor (non-resonant type) has a structure that can detect vibrations between approximately 5 kHz and 15 kHz. The knock control sensor is fitted onto the engine block to detect engine knocking. The knock control sensor contains a piezoelectric element which gene
© 2016-2025 Copyright www.lexguide.net
