Lexus ES: Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message (U023587)
DESCRIPTION
The forward recognition camera communicates with the millimeter wave radar sensor assembly via CAN communication. If a communication malfunction between the forward recognition camera and millimeter wave radar sensor assembly is detected, DTC U023587 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from |
|---|---|---|---|---|---|
| U023587 | Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message | When the engine switch is on (IG) for 3 seconds or more and the dynamic radar cruise control system is operating, a communication malfunction between the millimeter wave radar sensor assembly and forward recognition camera is detected for approximately 2 seconds or more. | Pre-collision system | Does not come on | Radar Cruise2 |
PROCEDURE
| 1. | GO TO PRE-COLLISION SYSTEM |
HINT:
If DTC U023587 is output by the dynamic radar cruise control system, perform troubleshooting for the pre-collision system.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
Internal Control Module Software Incompatibility Not Programmed (U030051)
DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the ECM, the forward recognition camera stores DTC U030051. DTC No. Detection Item DTC Detection Co
Internal Control Module Software Incompatibility Invalid/Incompatible Software Component (U030057)
DESCRIPTION If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the ECM, the forward recognition camera stores DTC U030057. DTC No.
Software Incompatibility with Brake System Control Module Not Programmed (U031851)
DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the skid control ECU (brake actuator assembly), the forward recognition camera stores DTC U031851. DTC
SEE MORE:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT NOTICE: This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. INSTALL STRAIGHT PIN NOTICE: It is not necessary to remove the straight pins unless they
Camshaft Position Sensor "A" Circuit Bank 1 or Single Sensor (P034000,P034031)
DESCRIPTION If the cam position signal pulse sent from the ECM via a direct line is abnormal, the motor generator control ECU (MG ECU) (built into the inverter with converter assembly) stores DTC P034000 or P034031. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning
