Lexus ES: Lost Communication with Brake System Control Module (U0129,U0140,U0293)
DESCRIPTION
These DTCs are stored when the CAN communication system is malfunctioning.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0129 | Lost Communication with Brake System Control Module | The vehicle approaching speaker controller does not receive data from the skid control ECU (brake booster with master cylinder assembly) for approximately 10 seconds or more. |
|
| U0140 | Lost Communication with Body Control Module | The vehicle approaching speaker controller does not receive data from the main body ECU (multiplex network body ECU) for approximately 10 seconds or more. |
|
| U0293 | Lost Communication with Hybrid/EV Powertrain Control Module | The vehicle approaching speaker controller does not receive data from the hybrid vehicle control ECU for approximately 10 seconds or more. |
|
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Trouble Codes.
(e) Check for DTCs.
Body Electrical > Vehicle Proximity Notification System > Trouble CodesHINT:
When DTCs indicating a CAN communication system malfunction are output, perform troubleshooting for the CAN communication system before the vehicle proximity notification system.
| NEXT | .gif) | GO TO CAN COMMUNICATION SYSTEM |
READ NEXT:
There is No Sound Made
DESCRIPTION Based on signals received from each ECU, the vehicle approaching speaker controller outputs warning sounds through the vehicle approaching speaker assembly. WIRING DIAGRAM CAUTION / NOTIC
SEE MORE:
Replacement
REPLACEMENT CAUTION / NOTICE / HINT CAUTION: To avoid the danger of being burned, do not remove the reserve tank cap or drain cock plug while the coolant (for inverter) is still hot. Pressurized, hot coolant (for inverter) and steam may be released and cause serious burns. *1 Reserve Tank Cap
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY (w/ Manual (SOS) Switch) (a) Engage the 5 clamps to install the No. 3 antenna cord sub-assembly. (b) Connect the connector. 2. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY HINT: Butyl tape and adhesive tape are not available as supply part
