Lexus ES: Key-off Operation Function Operates even if Operating Conditions are not Satisfied
DESCRIPTION
According to the panoramic moon roof switch (map light sub-assembly) operation, the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) operates its built-in motor. Using the panoramic moon roof switch (map light sub-assembly), if the sliding roof glass or roof sunshade can be operated normally when 45 seconds or more have elapsed since the engine switch was turned off, the key-off operation function may be abnormal.
CAUTION / NOTICE / HINT
NOTICE:
-
If the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) must be initialized.
Click here
.gif)
-
The panoramic moon roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to How to Proceed with Troubleshooting.
Click here
-
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
Click here
PROCEDURE
| 1. | CHECK POWER WINDOW CONTROL SYSTEM |
(a) Check if the key-off operation function of the power window control system operates normally.
Click here
OK:
The key-off operation function of the power window control system operates normally.
| NG | .gif) | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
|
.gif)
| 2. | CHECK KEY-OFF OPERATION FUNCTION |
(a) Check the key-off operation function.
Click here
| Result | Proceed to |
|---|---|
| Sliding roof can still be operated even after approximately 45 seconds have elapsed after engine switch is turned off | A |
| Roof sunshade can still be operated even after approximately 45 seconds have elapsed after engine switch is turned off | B |
| A | | REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) |
| B | | REPLACE ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) |
READ NEXT:
Panoramic Moon Roof System does not Operate
DESCRIPTION The sliding roof ECU (sliding roof drive gear assembly) and roof sunshade ECU (sliding roof drive gear assembly) receive each other's position information from the main body ECU (multiplex
Components
COMPONENTS ILLUSTRATION *A for Front Side *B for Rear Side *1 FRONT SLIDING ROOF GARNISH LH *2 FRONT SLIDING ROOF GARNISH RH *3 SLIDING ROOF GLASS SUB-ASSEMBLY *4 SLIDING
SEE MORE:
Vehicle Speed Sensor (B2415)
DESCRIPTION The headlight ECU sub-assembly LH receives speed signals from the skid control ECU (brake booster with master cylinder assembly) via CAN communication and performs light control. for LED Type Turn Signal Light DTC No. Detection Item DTC Detection Condition Trouble Area DTC Out
Master Cylinder Pressure Circuit (C1786)
DESCRIPTION The absorber control ECU stores this DTC when a malfunction signal from the master cylinder pressure sensor built into the brake actuator assembly is received via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory C1786
