Lexus ES: Key-off Operation Function Operates even if Operating Conditions are not Satisfied
DESCRIPTION
The sliding roof ECU (sliding roof drive gear sub-assembly) operates its built-in motor according to the sliding roof switch (map light sub-assembly) operation. Using the sliding roof switch (map light sub-assembly), if the sliding roof can be operated normally when 45 seconds or more have elapsed since the power switch was turned off, the key-off operation function may be abnormal.
CAUTION / NOTICE / HINT
NOTICE:
-
If the sliding roof ECU (sliding roof drive gear sub-assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear sub-assembly) must be initialized.
Click here
.gif)
-
The sliding roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to How to Proceed with Troubleshooting.
Click here
-
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
Click here
PROCEDURE
| 1. | CHECK POWER WINDOW CONTROL SYSTEM |
(a) Check if the key-off operation function of the power window control system operates normally.
Click here
OK:
The key-off operation function of the power window control system operates normally.
| OK | .gif) | REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
| NG | | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
READ NEXT:
Sliding Roof does not Move by Operating Sliding Roof Control Switch
DESCRIPTION The sliding roof ECU (sliding roof drive gear sub-assembly) receives slide and tilt signals and operates its built-in motor when the sliding roof switch (map light sub-assembly) is operate
Vehicle Approaching Speaker (for Front Side)
ComponentsCOMPONENTS ILLUSTRATION *1 COOL AIR INTAKE DUCT SEAL *2 VEHICLE APPROACHING SPEAKER ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1.
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL OIL PUMP REGULATOR RING (a) Install the oil pump regulator ring to the oil pump body. *1 Oil Pump Regulator Vane *2 Oil Pump Regulator Ring *3 Oil Pump Relief Valve Spring *4 Vane Spring (b) Install the 2 oil pump regulator
Components
COMPONENTS ILLUSTRATION *A for HV Model *B for Gasoline Model *1 RADIO SETTING CONDENSER *2 REAR DOOR SCUFF PLATE LH *3 REAR SEAT SIDE GARNISH LH *4 ROOF SIDE INNER GARNISH ASSEMBLY LH *5 CLIP - - ● Non-reusable part - -
