Lexus ES: Installation

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Remote Touch / Installation

INSTALLATION

PROCEDURE

1. INSTALL REMOTE OPERATION CONTROLLER ASSEMBLY

(a) Install the remote operation controller assembly with the 4 screws as shown in the illustration.

Install in this Direction

2. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

Click here

3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

for UA80E:

Click here

for P710:

Click here

UB80F:

Click here

4. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Click here

5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

Click here

6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

Click here

SEE MORE:

System Description

SYSTEM DESCRIPTION SLIDING ROOF SYSTEM DESCRIPTION (a) The sliding roof system controls the sliding roof operation using the sliding roof ECU (sliding roof drive gear sub-assembly). Operating the sliding roof switch (map light sub-assembly) results in electrical power being transmitted to the slidin

Transmission Range Sensor "A" Circuit Open (P070513,P070562)

DESCRIPTION The park/neutral position switch assembly detects the shift position and sends signals to the ECM. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P070513 Transmission Range Sensor "A" Circuit Open All switches are off simultaneously for

Lexus ES: Installation

READ NEXT:

Removal

Removal

Park Assist / Monitoring

SEE MORE:

System Description

Transmission Range Sensor "A" Circuit Open (P070513,P070562)