Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Audio / Video / Rear Door Speaker / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR SPEAKER ASSEMBLY
NOTICE:
Do not touch the speaker cone.
(a) Engage the 2 guides to temporarily install the rear speaker assembly.
(b) Install the rear speaker assembly with the 2 screws.
(c) w/ Sub Wire Harness:
(1) Connect the connector.
2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Click here .gif)
3. INSTALL COURTESY LIGHT ASSEMBLY
Click here
4. INSTALL REAR DOOR TRIM UPPER PAD
Click here
5. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
Click here
6. INSPECT POWER WINDOW OPERATION
for HV Model: Click here
for Gasoline Model: Click here
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASS
Components
COMPONENTS ILLUSTRATION *A for HV Model *B for Gasoline Model *1 REAR DOOR SCUFF PLATE LH *2 REAR DOOR SCUFF PLATE RH *3 REAR SEAT SIDE GARNISH LH *4 REAR SEAT SIDE GARNI
SEE MORE:
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. SEPARATE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP (a) for TMC Made: (1) Secure the drive shaft in a vise between aluminum plates. NOTICE: Do
Transmission Fluid Temperature Sensor "A" Circuit Range/Performance (P071000)
DESCRIPTION The ATF temperature sensor converts the automatic transaxle fluid (ATF) temperature into a resistance value for use by the ECM. The ECM applies a voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature
© 2016-2026 Copyright www.lexguide.net
