Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Exterior Panels / Trim / Front Pillar Upper Cover / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL FRONT DOOR FRONT LOWER FRAME UPPER COVER
(a) Engage the 2 guides.
(b) Install the front door front lower frame upper cover with the nut.
2. INSTALL FRONT DOOR TRIM BRACKET
Click here .gif)
3. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
Click here
4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
5. INSTALL COURTESY LIGHT ASSEMBLY
Click here
6. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
8. INSTALL NO. 2 DOOR TRIM PAD
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT RADIATOR SIDE AIR GUIDE PLATE LH *2 FRONT RADIATOR SIDE AIR GUIDE PLATE RH *3 RADIATOR SHUTTER SUB-ASSEMBLY *4 THERMISTOR ASSEMBLY N*m (kgf*
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during gri
SEE MORE:
Components
COMPONENTS ILLUSTRATION *A for Gasoline Model 2WD *B for RH Side *C for LH Side - - *1 NO. 1 FLOOR UNDER COVER *2 NO. 2 FLOOR UNDER COVER N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *A for HV Model *B for RH Side *C for LH Side
Components
COMPONENTS ILLUSTRATION *A for TMC Made *B Type A *C Type B - - *1 COMPRESSOR ASSEMBLY WITH MAGNETIC CLUTCH *2 DRIVE SHAFT BEARING BRACKET *3 ENGINE COVER BRACKET *4 ENGINE OIL LEVEL DIPSTICK GUIDE *5 GENERATOR ASSEMBLY *6 IGNITION COIL ASSEMBLY
© 2016-2025 Copyright www.lexguide.net
