Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL ABSORBER CONTROL ECU
(a) Install the absorber control ECU with the 2 nuts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
NOTICE:
- Avoid any impact to the absorber control ECU.
- Do not drop the absorber control ECU. If it is dropped, replace it with a new one.
(b) Connect the 2 connectors to the absorber control ECU.
2. INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER RH
Click here .gif)
3. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH
Click here
4. INSTALL REAR FLOOR FINISH PLATE
Click here
5. INSTALL SPARE WHEEL COVER TRAY
Click here
6. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
Click here
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
8. PERFORM TEST MODE PROCEDURE
NOTICE:
After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.
Click here
READ NEXT:
Tire And Wheel
ComponentsCOMPONENTS ILLUSTRATION *1 WHEEL ASSEMBLY *2 AXLE HUB NUT Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*
SEE MORE:
USB Audio System Recognition/Play Error
DESCRIPTION When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by the radio receiver assembly. This diagnostic procedure is for when a device is not recognized, or fi
Open in One Side of Bus 1 Branch Line
DESCRIPTION When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Check" screen changes in
