Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL ELECTRIC VEHICLE BATTERY PLUG ASSEMBLY
CAUTION:
Be sure to wear insulated gloves and protective goggles.
(a) Install the electric vehicle battery plug assembly to the HV battery with the bolt.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(b) Connect the hybrid battery terminal block connector.
NOTICE:
Make sure that the connector is connected securely.
(c) Connect the HV battery junction block assembly connector.
NOTICE:
Make sure that the connector is connected securely.
(d) Engage the 2 claws to close the wiring harness protector.
(e) Connect the electric vehicle battery plug assembly connector.
2. INSTALL NO. 1 HV BATTERY COVER PANEL RH
Click here .gif)
3. INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY
Click here
4. INSTALL REAR UNDER COVER
Click here
5. INSTALL REAR UNDER SIDE COVER LH
Click here
6. INSTALL REAR DOOR SCUFF PLATE LH
Click here
7. INSTALL REAR UNDER SIDE COVER RH
Click here
8. INSTALL REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
9. INSTALL REAR SEAT CUSHION LOCK HOOK
Click here
10. INSTALL REAR SEAT CUSHION ASSEMBLY
Click here
11. INSTALL SERVICE PLUG GRIP
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 UPPER HV BATTERY COVER SUB-ASSEMBLY *2 BATTERY VOLTAGE SENSOR *3 NO. 1 HV BATTERY SHIELD PANEL - - N*m (kgf*cm, ft.*lbf): Specified torque - -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during batt
SEE MORE:
Back Camera Disconnected (C1622)
DESCRIPTION This DTC is stored if the radio receiver assembly judges that the signals or signal lines between the rear television camera assembly and the multi-display assembly are not normal as a result of its self check. DTC No. Detection Item DTC Detection Condition Trouble Area C162
Radio Broadcast cannot be Received or Poor Reception
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio receiver assembly, alw
