Lexus ES: Battery Voltage Sensor
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Hybrid / Battery Control / Battery Voltage Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 UPPER HV BATTERY COVER SUB-ASSEMBLY *2 BATTERY VOLTAGE SENSOR *3 NO. 1 HV BATTERY SHIELD PANEL - - N*m (kgf*cm, ft.*lbf): Specified torque - -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during batt
Installation
INSTALLATION PROCEDURE 1. INSTALL BATTERY VOLTAGE SENSOR CAUTION: Be sure to wear insulated gloves and protective goggles. (a) Install the battery voltage sensor to the HV battery with the bolt. To
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis > Front Recognition Camera > Trouble Codes (e) Check for DTCs (Test Failed / Pending / Confirmed). Techstream Display
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect
© 2016-2026 Copyright www.lexguide.net
