Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fxs (fuel) / Fuel Pump Ecu / Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL PUMP CONTROL ECU BRACKET
(a) Install the fuel pump control ECU bracket to the fuel pump control ECU with the 2 bolts.
Torque:
4.5 N·m {46 kgf·cm, 40 in·lbf}
2. INSTALL FUEL PUMP CONTROL ECU
(a) Install the fuel pump control ECU to the vehicle body with the nut.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
(b) Connect the 2 fuel pump control ECU connectors.
(c) Return the room partition panel insulator to its original position.
(d) w/ Silencer Sheet:
(1) Install the No. 2 room partition panel silencer sheet to the room partition panel insulator.
3. INSTALL REAR SEAT SIDE GARNISH LH
Click here .gif)
4. INSTALL REAR DOOR SCUFF PLATE LH
Click here
5. INSTALL REAR SEAT ASSEMBLY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Type A - - *1 FUEL SENDER GAUGE ASSEMBLY *2 FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY ILLUSTRATION *A for Type B - - *1 FUEL
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel
SEE MORE:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System (for H
Fuel Pump Control General Electrical Failure (P12D501)
DESCRIPTION Refer to DTC P062712. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P12D501 Fuel Pump Control General Electrical Failure When the fuel pump control ECU operation duty ratio is 3 to 65%, the fuel pump control ECU detects a
© 2016-2026 Copyright www.lexguide.net
