Lexus ES manuals

Lexus ES: Installation

Lexus ES (XZ10) Service Manual / Drivetrain / Ua80e (automatic Transmission / Transaxle) / Combination Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY)

(a) Install the drive mode select switch (combination switch assembly) to the instrument cluster finish panel assembly with the 3 screws.

(b) Engage the clamp to connect the wire harness to the instrument cluster finish panel assembly.

(c) Connect the drive mode select switch (combination switch assembly) connector.

2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click here

READ NEXT:

 Removal

REMOVAL PROCEDURE 1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Click here 2. REMOVE DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) (a) Disconnect the drive mode select switch (comb

 Differential Case

 Components

COMPONENTS ILLUSTRATION *1 FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING (INNER RACE) *2 FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING (OUTER RACE) *3 FRONT DIFFERENTIAL

SEE MORE:

 Parts Location

PARTS LOCATION ILLUSTRATION *A w/o AVS - - *1 FRONT AXLE HUB SUB-ASSEMBLY RH - FRONT SPEED SENSOR ROTOR RH *2 FRONT SPEED SENSOR RH *3 FRONT AXLE HUB SUB-ASSEMBLY LH - FRONT SPEED SENSOR ROTOR LH *4 FRONT SPEED SENSOR LH *5 REAR AXLE HUB AND BEARING ASSEMBLY RH -

 Switch Lights of Remote Touch do not Illuminate

DESCRIPTION Power is supplied to the remote touch (remote operation controller assembly) illumination when the light control switch is in the tail or head position. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuse for circuits related to this system before performing the following pr

© 2016-2026 Copyright www.lexguide.net