Lexus ES: Installation

Lexus ES (XZ10) Service Manual / Brake / Parking Brake / Electric Parking Brake Actuator / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY

(a) Apply a light coat of lithium soap base glycol grease to a new O-ring.

(b) Install the O-ring to the rear disc brake cylinder assembly.

NOTICE:

Make sure to replace the O-ring with a new one when installing the parking brake actuator assembly.

(c) Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly to the rear disc brake cylinder assembly with the 2 bolts.

Torque:

8.4 N·m {86 kgf·cm, 74 in·lbf}

2. CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

(a) Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.

3. INSTALL REAR WHEEL

Click here

SEE MORE:

AVC-LAN Circuit

DESCRIPTION Each unit of the navigation system connected to the AVC-LAN (communication bus) transmits switch signals via AVC-LAN communication. If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible. WIRING DI

Diagnosis System

DIAGNOSIS SYSTEM DESCRIPTION (a) The motor generator control ECU (MG ECU) (inverter with converter assembly) has a self-diagnosis system. If the motor generator control ECU (MG ECU), motor generator system or a component is not working properly, the ECU records the conditions that relate to the faul

Lexus ES: Installation

READ NEXT:

On-vehicle Inspection

Removal

Electric Parking Brake Switch

SEE MORE:

AVC-LAN Circuit

Diagnosis System