Lexus ES: Hv Relay Assembly
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Hybrid / Battery Control / Hv Relay Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 BATTERY SERVICE HOLE COVER *2 SERVICE PLUG GRIP ILLUSTRATION *1 CONNECTOR COVER ASSEMBLY *2 ENGINE ROOM MAIN WIRE Tightening torque for "Major
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during HV b
Inspection
INSPECTION PROCEDURE 1. INSPECT HV BATTERY JUNCTION BLOCK ASSEMBLY (a) Inspect SMRB: (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connect
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD Click here 2. INSTALL BRAKE MASTER CYLINDER O-RING (a) Install a new brake master cylinder O-ring to the brake master cylinder sub-assembly. 3. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY NOTICE: When installing a new brake master
Smart access system with push-button
start
The following operations can be
performed simply by carrying the
electronic key on your person, for
example in your pocket. The driver
should always carry the electronic
key.
Locks and unlocks the doors
Opens the trunk
Starts the hybrid system
■Antenna location
Antennas outsi
© 2016-2026 Copyright www.lexguide.net
