Lexus ES: Fuel Tank Pressure Sensor
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fxs (emission Control) / Fuel Tank Pressure Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR FLOOR SERVICE HOLE COVER *2 BUTYL TAPE *3 FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR) *4 TUBE JOINT CLIP ● Non-reusable part - -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel
Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR) (a) Push the fuel tank pressure sensor (vapor pressure sensor) onto the fuel tank assembly, then install the tube
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR SPOILER SUB-ASSEMBLY (w/ Rear Spoiler) Click here 2. INSTALL LICENSE PLATE LIGHT ASSEMBLY LH Click here 3. INSTALL LICENSE PLATE LIGHT ASSEMBLY RH HINT: Use the same procedure as for the LH side. 4. INSTALL TELEVISION CAMERA ASSEMBLY WITH WIRE Click here 5.
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during automatic transaxle fluid replacement are shown below. Necessary Procedures After Parts Removed/Insta
© 2016-2026 Copyright www.lexguide.net
