Lexus ES: Fuel Pump
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Type A *B for Type B *1 FUEL PUMP GAUGE RETAINER *2 FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY *3 FUEL TANK MAIN TUBE SUB-ASSEMBLY *4 F
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly o
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT AIR FUEL RATIO SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 (HA1B) - 2 (+B) 20°C (68°F) 2 to 6 Ω 1 (HA1B) - 4 (A1B-) Always 10 kΩ o
ENG / EHV Device (C1A40)
DESCRIPTION When a SFI system malfunction signal sent by the hybrid vehicle control ECU is detected by the clearance warning ECU assembly, DTC C1A40 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C1A40 ENG / EHV Device When the power switch on (IG), a SFI sys
© 2016-2026 Copyright www.lexguide.net
