Lexus ES: Front Radar Sensor System (for Gasoline Model)
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Cruise Control / Front Radar Sensor System (for Gasoline Model)
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Utility
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Control History
- Front Radar Sensor Optical Axis Misalignment Malfunction (C1A1100)
- Main Microcomputer in Front Radar Sensor Calibration/Parameter Memory Failure (C1A8C46,C1A8D1C,C1A9000,C1A9100)
- Lost Communication with Cruise Control Module Missing Message (U010487)
- Software Incompatibility with Cruise Control Module Invalid/Incompatible Software Component (U030557)
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the c
Parts Location
PARTS LOCATION ILLUSTRATION *1 MILLIMETER WAVE RADAR SENSOR ASSEMBLY *2 FORWARD RECOGNITION CAMERA *3 HEADLIGHT ECU SUB-ASSEMBLY LH - - ILLUSTRATION *1 DLC3 *2 INSTRUM
System Diagram
SYSTEM DIAGRAM SYSTEM DIAGRAM LOCAL CAN CIRCUIT
SEE MORE:
Initialization
INITIALIZATION Inspection After Repair Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation. Details on procedures required are indicated by an asterisk and a number, and are explained in detail following the table. Part Replaced Engine O
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR BUMPER ASSEMBLY (a) w/ Wire Harness: (1) Connect the connector. (b) Engage the 6 claws as shown in the illustration. Install in this Direction (c) Engage the 6 claws as shown in the illustration. Install in this Direction HINT: Use the same
© 2016-2026 Copyright www.lexguide.net
