Lexus ES: Front Camera Response Malfunction (C2A6D)
DESCRIPTION
During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the front television camera assembly. This DTC is stored when the output of the front television camera assembly does not match the expected output.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
C2A6D | Front Camera Response Malfunction | Abnormal response from the front television camera assembly | -
Front television camera assembly
-
Parking assist ECU
|
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
OK:
DTC C2A6D is not output.
OK | | USE SIMULATION METHOD TO CHECK |
NG | | |
2. | REPLACE FRONT TELEVISION CAMERA ASSEMBLY |
(a) Replace the front television camera assembly with a new or normally functioning one.
Click here
NEXT | | |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
OK:
DTC C2A6D is not output.
OK | | END (FRONT TELEVISION CAMERA ASSEMBLY IS DEFECTIVE) |
NG | | REPLACE PARKING ASSIST ECU |
READ NEXT:
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the front television camera assembly via CAN communication. DTC No. Detection Item DTC De
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly LH via CAN communication. DTC No. Detection Item DTC
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly RH via CAN communication. DTC No. Detection Item DTC
SEE MORE:
DESCRIPTION The cause of this malfunction may be the generator high-voltage circuit. Check the generator internal resistance and the connection condition of the high-voltage line between the inverter and generator to check whether there is an open or short circuit. Related Parts Check Area Insp
REASSEMBLY CAUTION / NOTICE / HINT NOTICE: Steps 10 to 17 are temporary reassembly procedures for adjustment purposes. PROCEDURE 1. INSTALL STRAIGHT PIN (a) Using a plastic-faced hammer, install the 4 straight pins to the rear differential carrier sub-assembly. *a 8.0 to 9.0 mm (0.315 to 0.354
© 2016-2025 Copyright www.lexguide.net
