Lexus ES: Freeze Frame Data
FREEZE FRAME DATA
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Body Electrical > Navigation System > Trouble Codes(e) Select a DTC to display its freeze frame data.
LIST OF FREEZE FRAME DATA
Body Electrical > Navigation System| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Battery Voltage | Auxiliary battery voltage | Min.: 0 V, Max.: 24 V | 11 to 15.5 V | - |
| Active Dimmer | Active dimmer function | ON or OFF | ON: Active dimmer function on OFF: Active dimmer function off | - |
| Tail Light SW | Taillight switch | ON or OFF | ON: Light control switch in tail or head position OFF: Light control switch off or AUTO | - |
| Reverse Signal | Reverse signal | ON or OFF | ON: Shift lever in R OFF: Shift lever not in R | - |
| Parking Brake | Parking brake switch | ON or OFF | ON: Parking brake applied OFF: Parking brake released | - |
| Ignition | Power switch | ON or OFF | ON: Power switch on (IG) OFF: Power switch off or on (ACC) | "OFF" is displayed even though the power switch is on (ACC) |
| Vehicle Speed | Maximum wheel speed sensor reading | Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| HDMI Line(Blu-ray Disc Player) | - | Disconnected or Connected | Disconnected | Not available |
READ NEXT:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the audio and visual system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
Illumination Circuit
DESCRIPTION Power is supplied to the radio receiver assembly and steering pad switch assembly illumination when the light control switch is in the tail or head position. WIRING DIAGRAM CAUTION / NOTI
Illumination for Panel Switch does not Come on with Tail Switch ON
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre
SEE MORE:
Initialization
INITIALIZATION NOTICE:
Initialization can be confirmed through the tire pressure warning light.
If the engine switch is turned off during initialization, the tire pressure warning ECU and receiver memorizes that initialization was being performed. Therefore, it is not necessary to perform the i
Fail-safe Chart
FAIL-SAFE CHART DIAGNOSIS FUNCTION
Heated steering wheel controller (steering vibration ECU) has diagnosis function. Condition Detection Condition Response when malfunction detected Recovery Conditions ECU malfunction Internal malfunction detected in the heated steering wheel contr
