Lexus ES: Exhaust Manifold
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / 2gr-fks (intake / Exhaust) / Exhaust Manifold
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A Type A *B Type B *1 FRONT FLOOR COVER RH - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *A Type A *B Type B *1
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during exha
Installation
INSTALLATION PROCEDURE 1. INSTALL STUD BOLT HINT: If a stud bolt is deformed or its threads are damaged, replace it. (a) Using an E8 "TORX" socket wrench, install the 2 stud bolts to the exhaust ma
SEE MORE:
Initialization
INITIALIZATION NOTICE:
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly LH removal/installation are shown below. for LED Type Turn Signal Light Replaced
DC/DC Converter Voltage Sensor "A"(VL) Stuck On (P1CB59E)
DTC SUMMARY MALFUNCTION DESCRIPTION If an overvoltage malfunction occurs in the boost converter, the motor generator control ECU (MG ECU) detects the malfunction and stores this DTC. The cause of this malfunction may be one of the following: Internal inverter malfunction
Inverter with converter a
© 2016-2026 Copyright www.lexguide.net
