Lexus ES: Lost Communication with Body Control Module Missing Message (U014087,U015587,U016387)
Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Telematics / Telematics System (for Hv Model) / Lost Communication with Body Control Module Missing Message (U014087,U015587,U016387)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U014087 | Lost Communication with Body Control Module Missing Message | CAN reception error | CAN communication system |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | CAN reception error | CAN communication system |
| U016387 | Lost Communication with Navigation Control Module Missing Message | CAN reception error | CAN communication system |
PROCEDURE
| 1. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs(b) Recheck for DTCs and check if the same DTCs are output again.
Body Electrical > Telematics > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTCs are output. | B |
| A |  | USE SIMULATION METHOD TO CHECK |
| B | | GO TO CAN COMMUNICATION SYSTEM |
READ NEXT:
Utility
UTILITY CANCEL COMMUNICATION FUNCTION PAUSING HINT: This function is used to cancel communication function pausing mode. (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c)
Warning Notification Function Malfunction
PROCEDURE 1. CHECK PROBLEM SYMPTOM (WARNING NOTIFICATION FUNCTION) (a) Check the problem symptom. (1) Check the problem symptom of the warning notification function. Result Proceed to
Warning Notification Function Malfunction
PROCEDURE 1. CHECK PROBLEM SYMPTOM (WARNING NOTIFICATION FUNCTION) (a) Check the problem symptom. (1) Check the problem symptom of the warning notification function. Result Proceed to
SEE MORE:
Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch
DESCRIPTION If the manual up and down functions operate normally but the auto up and down functions do not, the power window control system may be in fail-safe mode. If power window initialization has not been performed, the auto up and down functions will not operate. Click here WIRING DIAGRAM C
Components
COMPONENTS ILLUSTRATION *1 UPPER HV BATTERY COVER SUB-ASSEMBLY *2 BATTERY VOLTAGE SENSOR *3 NO. 1 HV BATTERY SHIELD PANEL - - N*m (kgf*cm, ft.*lbf): Specified torque - -
© 2016-2026 Copyright www.lexguide.net
