Lexus ES: Dtc Check / Clear
Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Cellular Communication / Safety Connect System (for Hv Model) / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Trouble Codes.
Body Electrical > Telematics > Trouble Codes(e) Check for DTCs and write them down.
(f) Check the details of the DTC(s).
Click here .gif)
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Clear DTCs.
Body Electrical > Telematics > Clear DTCs(e) Clear the DTCs.
READ NEXT:
Emergency Call Switch Illumination Circuit
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be need
Green Indicator Remains Off
DESCRIPTION After power switch on (IG), the DCM (telematics transceiver) will enter into self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn off followed by t
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the safety connect system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
SEE MORE:
Back Camera Disconnected (C1622)
DESCRIPTION This DTC is stored if the radio receiver assembly judges that the signals or signal lines between the rear television camera assembly and the multi-display assembly are not normal as a result of its self check. DTC No. Detection Item DTC Detection Condition Trouble Area C162
Components
COMPONENTS ILLUSTRATION *1 ENGINE OIL PRESSURE SWITCH ASSEMBLY *2 FRONT FENDER APRON SEAL RH *3 WIRE HARNESS PROTECTOR - - N*m (kgf*cm, ft*lbf): Specified torque Adhesive 1344 ★ Precoated part - -
© 2016-2026 Copyright www.lexguide.net
