Lexus ES manuals

Lexus ES: Installation

Lexus ES (XZ10) Service Manual / Vehicle Exterior / Lighting (ext) / Headlight Assembly (for Bulb Type Turn Signal Light) / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL HEADLIGHT ASSEMBLY

Click here

2. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY

Click here

3. INSTALL COWL TOP PANEL INSULATOR

Click here

4. INSTALL FRONT BUMPER ASSEMBLY

Click here

5. PERFORM INITIALIZATION

for HV Model:

Click here

for Gasoline Model:

Click here

6. ADJUST HEADLIGHT AIMING

Click here

READ NEXT:

 Repair

REPAIR CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. If the installation area of the headlight assembly is damage

 Headlight Assembly (for Led Type Turn Signal Light)

 Components

COMPONENTS ILLUSTRATION *1 COWL TOP PANEL INSULATOR *2 FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY *3 HEADLIGHT ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - I

SEE MORE:

 Master Cylinder Pressure Circuit (C1786)

DESCRIPTION The absorber control ECU stores this DTC when a malfunction signal from the master cylinder pressure sensor built into the brake actuator assembly is received via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory C1786

 Installation

INSTALLATION PROCEDURE 1. INSTALL ABSORBER CONTROL ECU (a) Install the absorber control ECU with the 2 nuts. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} NOTICE: Avoid any impact to the absorber control ECU. Do not drop the absorber control ECU. If it is dropped, replace it with a new one. (b)

© 2016-2026 Copyright www.lexguide.net