Lexus ES: Dtc Check / Clear
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Door / Hatch / Power Trunk Lid System (for Gasoline Model) / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Back Door / Trouble Codes.
Body Electrical > Back Door > Trouble Codes(e) Check for DTCs.
Click here
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Back Door / Trouble Codes.
Body Electrical > Back Door > Clear DTCs(e) Clear the DTCs.
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Power Trunk Lid System DTC No. Detection Item Link B2205 Kick Sensor Circuit B2222 PBD/PTL Pulse Sensor B2225 PBD/PTL Motor Clutch Malf
Kick Sensor Circuit (B2205)
DESCRIPTION DTC B2205 is output when the luggage closer motor assembly detects that the kick door control sensor is stuck on. DTC No. Detection Item DTC Detection Condition Trouble Area B
SEE MORE:
Components
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *1 COURTESY LIGHT ASSEMBLY *2 FRONT DOOR ILLUMINATION LIGHT (FRONT DOOR OUTSIDE HANDLE ASSEMBLY) *3 FRONT DOOR SERVICE HOLE COVER *4 FRONT DOOR TRIM BOARD SUB-ASSEMBLY *5 MULTIPLEX NETWORK MAST
Installation
INSTALLATION PROCEDURE 1. INSTALL PANORAMIC VIEW MONITOR SWITCH (NO. 2 COMBINATION SWITCH ASSEMBLY) (a) Engage the 4 claws to install the panoramic view monitor switch (No. 2 combination switch assembly) as shown in the illustration. Install in this Direction 2. INSTALL LOWER INSTRUMENT PA
© 2016-2026 Copyright www.lexguide.net
