Lexus ES: Diagnostic Trouble Code Chart
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Door / Hatch / Power Trunk Lid System (for Gasoline Model) / Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Power Trunk Lid System| DTC No. | Detection Item | Link |
|---|---|---|
| B2205 | Kick Sensor Circuit | |
| B2222 | PBD/PTL Pulse Sensor | |
| B2225 | PBD/PTL Motor Clutch Malfunction | |
| B2250 | PBD/PTL Closer Operation | |
| B2251 | PBD/PTL Closer Switch | |
| U0101 | Lost Communication with TCM | |
| U0122 | Lost Communication With Vehicle Dynamics Control Module | |
| U0142 | Lost Communication With Body Control Module "B" | |
| U0155 | Lost Communication With Instrument Panel Cluster (IPC) Control Module | |
| U0327 | Lost Communication with Vehicle Security Control Module | |
| U1117 | Lost Communication with Accessory Gateway | |
.gif)
READ NEXT:
Kick Sensor Circuit (B2205)
DESCRIPTION DTC B2205 is output when the luggage closer motor assembly detects that the kick door control sensor is stuck on. DTC No. Detection Item DTC Detection Condition Trouble Area B
PBD/PTL Pulse Sensor (B2222,B2225)
DESCRIPTION DTC B2222 is output when there is a malfunction in the door pulse sensor system inside the luggage closer motor assembly and a normal waveform is not input to the door pulse sensor during
PBD/PTL Closer Operation (B2250)
DESCRIPTION DTC B2250 is stored when there is a malfunction in the closer pulse sensor circuit of the luggage door closer assembly and when a normal waveform is not input for the closer pulse during p
SEE MORE:
Shutter Control State Maintenance Mode (B1333)
DESCRIPTION This DTC is stored when the grille shutter system is changed to maintenance mode. DTC No. Detection Item DTC Detection Condition Trouble Area B1333 Shutter Control State Maintenance Mode The grille shutter system is changed to maintenance mode. Swing grille actuator as
Removal
REMOVAL PROCEDURE 1. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL Click here 2. REMOVE OUTER MIRROR SWITCH ASSEMBLY (a) Using a screwdriver, disengage the 4 claws and remove the outer mirror switch assembly. HINT: Tape the screwdriver tip before use
© 2016-2025 Copyright www.lexguide.net
