Lexus ES: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Lane Control / Trouble Codes.
Chassis > Lane Control > Trouble Codes(e) Check for DTCs (Test Failed / Pending / Confirmed).
| Techstream Display | Description |
|---|---|
| Test Failed | Represent malfunctions that were detected during the current trip. |
| Pending | Represent malfunctions which have occurred since the DTCs were last cleared but have not been confirmed. |
| Confirmed | Represent malfunctions which have occurred since the DTCs were last cleared and have been confirmed. (The number of trips since the DTC was stored may differ for each DTC.) |
HINT:
Freeze frame data is stored respectively for pending DTCs, confirmed DTCs and the latest DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Lane Control / Clear DTCs.
Chassis > Lane Control > Clear DTCs(e) Clear the DTCs.
HINT:
Clearing the DTCs will also clear the freeze frame data.
READ NEXT:
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When a malfunction occurs in the lane control system, a message will be displayed on the multi-information display and, depending on the malfunction, functions o
Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) Whenever a lane control system DTC is stored, the forward recognition camera stores the current vehicle state as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connec
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
SEE MORE:
Brake Switch "A" Circuit Short to Battery (P057112)
DESCRIPTION The skid control ECU (brake actuator assembly) receives stop light switch assembly signals and uses them to determine whether or not the brakes are applied. DTCs may be stored if either of the following occurs:
Stop light switch assembly stuck on malfunction.
The accelerator and bra
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below. Necessary Procedures After Parts Removed/Installed
