Lexus ES manuals

Lexus ES: Does not Recognize Voice Commands Performed to Contact Support Center

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Cellular Communication / Lexus Enform System (for Gasoline Model) / Does not Recognize Voice Commands Performed to Contact Support Center

PROCEDURE

1.

CHECK COMMUNICATION BASED VOICE RECOGNITION FUNCTION

(a) While paying attention to the condition of the spoken voice command, say "Find a gas station in New York" and check that voice recognition is operating normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Find a gas station in New York" is spoken, "Find a gas station in New York" is displayed in the voice recognition result display area.)
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).

OK:

Voice command is recognized normally.

OK

END
NG

CONTACT SERVICE CENTER

READ NEXT:

 How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the LEXUS ENFORM system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT

 Operation Check

OPERATION CHECK LEXUS APP SUITE RESET PROCEDURE (a) Duplicate the problem symptom. (b) Check for DTCs and repair the systems for which any DTCs are output. Click here (c) Check cellular phone compa

 Parts Location

PARTS LOCATION ILLUSTRATION *1 ROOF ANTENNA ASSEMBLY - GPS - Telephone Main *2 FRONT NO. 2 SPEAKER ASSEMBLY RH *3 NAVIGATION ANTENNA ASSEMBLY - Telephone Sub *4 DLC3 *5 DCM (

SEE MORE:

 Parts Location

PARTS LOCATION ILLUSTRATION *1 TIRE PRESSURE WARNING ECU AND RECEIVER *2 TIRE PRESSURE WARNING VALVE AND TRANSMITTER ILLUSTRATION *1 STEERING PAD SWITCH ASSEMBLY *2 COMBINATION METER ASSEMBLY - TIRE PRESSURE WARNING LIGHT - MULTI-INFORMATION DISPLAY *3 MAIN BODY ECU (MUL

 Drive Mode Select Switch Circuit

DESCRIPTION The characteristics of the electronic throttle and EPS operation change according to operation of the drive mode select switch (combination switch assembly). WIRING DIAGRAM PROCEDURE 1. CHECK THE PROBLEM SYMPTOMS (a) Check each symptom by checking the suspected areas in the tab

© 2016-2026 Copyright www.lexguide.net