Lexus ES manuals

Lexus ES: DCM System Internal Failure (B15A804)

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Cellular Communication / Safety Connect System (for Hv Model) / DCM System Internal Failure (B15A804)

DESCRIPTION

This DTC is stored when an internal circuit malfunction is detected by the DCM (telematics transceiver) self check.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15A804

DCM System Internal Failure

DCM (telematics transceiver) internal malfunction

DCM (telematics transceiver)

CAUTION / NOTICE / HINT

NOTICE:

  • Regardless of whether DTC B15A804 has been output as a present or history DTC, the DCM (telematics transceiver) should be replaced.
  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.

    Click here

PROCEDURE

1.

REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (telematics transceiver) with a new one.

Click here

NOTICE:

  • The power switch must be off.
  • Do not exchange the DCM (telematics transceiver) with one from another vehicle.
NEXT

PERFORM DCM ACTIVATION

READ NEXT:

 GNSS Antenna Circuit Short to Ground (B15C111,B15C113)

DESCRIPTION These DTCs are stored when a malfunction occurs in the telephone and GPS antenna assembly (for Roof Side) circuit. DTC No. Detection Item DTC Detection Condition Trouble Area

 Airbag Signal Signal Plausibility Failure (B15C464)

DESCRIPTION If the DCM (telematics transceiver) detects an error in communication between the DCM (telematics transceiver) and the airbag ECU assembly as a result of the DCM (telematics transceiver) s

 Emergency Call Switch Circuit Short to Ground (B15C511,B15C513)

DESCRIPTION If the DCM (telematics transceiver) detects an error in the communication between the DCM (telematics transceiver) and the map light sub-assembly (manual (SOS) switch) as a result of the D

SEE MORE:

 Stop Lamp Relay Actuator Stuck On (C13807E)

DESCRIPTION When any of the following conditions are met, the skid control ECU (brake actuator assembly) sets the drive output (STPO) ON which operates the stop light control relay (stop light switch assembly) and turns on the stop lights. Illumination Conditions: Pre-collision brake is operating

 Replacement

REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during automatic transaxle fluid replacement are shown below. Necessary Procedures After Parts Remov

© 2016-2026 Copyright www.lexguide.net