Lexus ES manuals

Lexus ES: Data List / Active Test

DATA LIST / ACTIVE TEST

DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Navigation System / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Navigation System > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Battery Voltage

Auxiliary battery voltage

Min.: 0 V, Max.: 24 V

11 to 15.5 V

-

Active Dimmer

Active dimmer function

ON or OFF

ON: Active dimmer function on

OFF: Active dimmer function off

-

Tail Light SW

Taillight switch

ON or OFF

ON: Light control switch in tail or head position

OFF: Light control switch off or AUTO

-

Reverse Signal

Reverse signal

ON or OFF

ON: Shift lever in R

OFF: Shift lever not in R

-

Parking Brake

Parking brake switch

ON or OFF

ON: Parking brake applied

OFF: Parking brake released

-

Ignition

Power switch

ON or OFF

ON: Power switch on (IG)

OFF: Power switch off or on (ACC)

"OFF" is displayed even though the power switch is on (ACC)

Vehicle Speed

Maximum wheel speed sensor reading

Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)

Vehicle stopped: 0 km/h (0 mph)

When driving at constant speed: No large fluctuations

HDMI Line(Blu-ray Disc Player)

-

Disconnected or Connected

Disconnected

Not available

READ NEXT:

 Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1.

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Navigation System DTC No. Detection Item Link B1323 Lost Communication with Haptic Device B1324 Lost Communication with Meter B1325 Los

 Disc cannot be Ejected

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

SEE MORE:

 Diagnosis System

DIAGNOSIS SYSTEM DESCRIPTION (a) When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the Techstream to the vehicle and reading various data output from the clearance warning ECU assembly. The clearance warning ECU assembl

 Throttle / Pedal Position Sensor / Switch "A" Circuit Short to Ground (P012011)

DESCRIPTION The throttle position sensor is built into the throttle body with motor assembly and detects the opening angle of the throttle valve. This sensor is a non-contact type sensor. It uses Hall-effect elements in order to yield accurate signals even in extreme driving conditions, such as at h

© 2016-2024 Copyright www.lexguide.net