Lexus ES manuals

Lexus ES: Disc cannot be Ejected

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System (for Hv Model) / Disc cannot be Ejected

CAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

    Click here

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio receiver assembly may not operate normally.

PROCEDURE

1.

CHECK OPERATION

(a) Press the disc eject switch of the radio receiver assembly for 5 seconds or more and check that the disc is ejected.

OK:

Disc is ejected.

NG

REPLACE RADIO RECEIVER ASSEMBLY

OK

2.

REPLACE DISC AND RECHECK

(a) Replace the disc with a new or known good one and check that the malfunction disappears.

OK:

Disc is ejected.

OK

END (DISC WAS FAULTY)
NG

REPLACE RADIO RECEIVER ASSEMBLY

READ NEXT:

 Disc cannot be Inserted or is Ejected Right After Insertion

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

 Display does not Dim when Light Control Switch is Turned ON

DESCRIPTION When the navigation system is activated with the light control switch in the tail or head position, before AVC-LAN communication is established, the multi-display assembly dims the display

 Does not Play even after Bluetooth Audio Mode is Selected

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

SEE MORE:

 Switch Failure (B2342)

DESCRIPTION This DTC is stored when the sliding roof ECU (sliding roof drive gear assembly) detects that the panoramic moon roof switch (map light sub-assembly) is stuck for 30 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B2342 Switch Failure Sliding

 Installation

INSTALLATION PROCEDURE 1. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) (a) Install a new gasket to the front exhaust pipe assembly (TWC: Rear Catalyst). (b) Connect the front exhaust pipe assembly (TWC: Rear Catalyst) to the 2 exhaust pipe supports. (c) Install the front exhaust pipe ass

© 2016-2026 Copyright www.lexguide.net