Lexus ES: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE LUGGAGE COMPARTMENT DOOR OPENER SYSTEM
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
HINT:
The following items can be customized.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / PSD & PBD operation or Door Lock.
(5) Select the setting by referring to the table below.
PSD & PBD operation| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Kick Sensor Function | Function that enables/disables the hands free power trunk lid | ON | 0:OFF,1:ON | Luggage closer motor assembly |
| PBD Power Operation | Status of the power trunk lid and luggage compartment door closer setting | ON | 00:OFF,01:ON(Closer Only),11:ON | Luggage closer motor assembly |
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Trunk Link with Door Lock | Function that opens the luggage compartment door when the luggage electrical key switch is pressed and all doors are unlocked using the entry door lock function, wireless door lock function, mechanical key or door control switch. | ON | 0:OFF,1:ON | Main body ECU (multiplex network body ECU) |
(b) Customizing with the combination meter assembly
(1) Turn the engine switch on (IG).
(2) Enter the following menus: Settings.
(3) Select the setting by referring to the table below.
| Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| KICK SENSOR | Function that can be used to set the hands free power trunk lid. | On | On or Off | Luggage closer motor assembly |
READ NEXT:
Initialization
INITIALIZATION INITIALIZE LUGGAGE CLOSER MOTOR ASSEMBLY NOTICE: Initialization of the luggage closer motor assembly (luggage compartment door initial position learning) is necessary if the following w
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration. Click here HINT:
Use the table below to help determine the cause of proble
Terminals Of Ecu
TERMINALS OF ECU CHECK LUGGAGE CLOSER MOTOR ASSEMBLY (a) Disconnect the R7 luggage closer motor assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below
SEE MORE:
Software Incompatibility with Cruise Control Module Invalid/Incompatible Software Component (U030557)
DESCRIPTION The millimeter wave radar sensor assembly receives vehicle information from the forward recognition camera via CAN communication. If the vehicle information stored in the forward recognition camera differs from that stored in the millimeter wave radar sensor assembly, the millimeter wave
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main Body ECU (Multiplex Network Body ECU) Sliding Roof ECU (Sliding Roof Drive Gear Sub-assembly)
Sliding roof operation permission signal
IG signal
Front door courtesy light switch assembly signal
Key-linked
