Lexus ES manuals

Lexus ES: Components

COMPONENTS

ILLUSTRATION

*1

BATTERY SERVICE HOLE COVER

*2

SERVICE PLUG GRIP

READ NEXT:

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during serv

 Inspection

INSPECTION PROCEDURE 1. INSPECT SERVICE PLUG GRIP (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Conditi

 Installation

INSTALLATION PROCEDURE 1. INSTALL SERVICE PLUG GRIP CAUTION: Be sure to wear insulated gloves. NOTICE: Before installing the service plug grip, check that no parts or tools remain and that the high vo

SEE MORE:

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear drive shaft assembly removal/installation are shown below. Necessary Procedures After Parts Remove

 Control Module Internal Temperature Sensor/Intake Air Temperature Sensor Signal Compare Failure (P111C62)

DESCRIPTION The engine has an ECM internal temperature sensor and intake air temperature sensor. The resistance of a thermistor within the ECM internal temperature sensor and intake air temperature sensor increases as the temperature decreases and decreases as the temperature increases. The voltage

© 2016-2026 Copyright www.lexguide.net