Lexus ES: Canister
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR NO. 1 STABILIZER BAR BRACKET *2 CANISTER (CHARCOAL CANISTER ASSEMBLY) *3 LEAK DETECTION PUMP SUB-ASSEMBLY *4 FUEL TANK VENT HOSE SUB-ASSEMBLY *5
Removal
REMOVAL PROCEDURE 1. REMOVE REAR NO. 1 STABILIZER BAR BRACKET (a) Remove the 4 bolts and 2 rear No. 1 stabilizer bar brackets from the vehicle body. 2. REMOVE CANISTER (CHARCOAL CANISTE
Inspection
INSPECTION PROCEDURE 1. INSPECT CANISTER (CHARCOAL CANISTER ASSEMBLY) (a) Visually check the canister (charcoal canister assembly). (1) Visually check the canister (charcoal canister assembly) for
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Start the engine. (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Engine / Active Test / Control the Exhaust VVT OCV Duty Ratio Bank 1. Powertrain &
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Rep
© 2016-2025 Copyright www.lexguide.net
