Lexus ES: Brake Pedal (for Hv Model)
READ NEXT:
Adjustment
ADJUSTMENT PROCEDURE 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT (a) Remove the front door scuff plate LH. Click here (b) Remove the cowl side trim board LH. Click here (c) Remove the No. 1 instrumen
Components
COMPONENTS ILLUSTRATION *1 FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping"
Installation
INSTALLATION PROCEDURE 1. INSTALL BRAKE PEDAL PAD (a) Install the brake pedal pad to the brake pedal support assembly. HINT: Installation is easier after applying a small amount of soapy water. 2. INS
SEE MORE:
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
rear disc brake pad removal/installation are shown below.
Necessary Procedures After Parts Remov
Radiator Coolant Temperature Sensor Circuit Short to Battery or Open (P00B115)
DESCRIPTION Refer to DTC P00B111. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P00B115 Radiator Coolant Temperature Sensor Circuit Short to Battery or Open The No. 2 engine coolant temperature sensor output voltage is higher than 4.9
© 2016-2026 Copyright www.lexguide.net
