Lexus ES: Brake Actuator (for Hv Model)
Lexus ES (XZ10) Service Manual / Brake / Brake Control / Dynamic Control Systems / Brake Actuator (for Hv Model)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT STABILIZER LINK ASSEMBLY RH - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm,
Inspection
INSPECTION PROCEDURE 1. INSPECT BRAKE ACTUATOR ASSEMBLY (a) Inspect the solenoid circuit. (1) Make sure that there is no looseness at the locking part and the connecting part of the connector. OK: Th
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: The parking brake indicator light blinks (red) when the power switch is turned on after replacing the brake actuator assembly. Operate the electric parking b
SEE MORE:
A/F (O2) Sensor Correlation Bank 1 Sensor 1/Bank 1 Sensor 2 Signal Compare Failure (P00D562)
DESCRIPTION Refer to DTC P003012. Click here Refer to DTC P003612. Click here HINT: Although the DTC title say O2 sensor, this DTC relate to the air fuel ratio sensors (sensor 1 and sensor 2). DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P00D562
Tilt and Telescopic ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Tilt and Telescopic ECU Communication Stop Mode Any of the following conditions are met:
Communication stop for "Multiplex Tilt and Telescopic" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Com
© 2016-2026 Copyright www.lexguide.net
